|
To select affected assembly |
|
|
|
|
To select affected assembly |
|
|
To select affected assembly
|
To select affected assembly |
|
|
|
|
To select affected assembly |
|
|
| 1. | Click on the IDN selection button <…> to the right of the FM; the NHA selection window opens. |
| 2. | From the NHA Selection window, select the affected assembly. |
| 3. | Choose OK. |
Note There are some limitations in IDN selection: any item with already defined/inherent failure modes cannot be selected; also any IDN that may cause a loop in the FM-NHE-EE chain, cannot be selected.