There are two product tree view modes for FMECA module – Normal View (with components) and Functional Blocks View (with FB displayed instead of assemblies). To switch from one mode to another, use View menu – Normal/Functional Block View mode. The example below shows the same assembly in two different view modes:

 

After choosing Functional Tree View, select the functional block and enter FMECA data in the same way as for components (as it was described above in the Entering FMECA data paragraph).

NOTE For a specific assembly, only one mode of FMECA analysis is allowed – either per components or per Functional Blocks. For different assemblies within the same project, both modes are allowed simultaneously.