From the Reports menu, choose Tree.

The Report Selection dialog box opens:

Note The fields displayed change according to the report type selected.

Several reports may be produced in FMECA.

When the Criticality Analysis check box in the Project Configuration dialog box is not checked, you can only choose non-quantitative reports. The list of reports in this case is FMEA and the Fault Tree.

When the Criticality Analysis check box is checked, you can choose any of the existing reports.

There are different parameters for each report that define which information will be included in the report.

See also "Reports" paragraph in the RAM Commander Fundamentals chapter for more general information about reports.